Dynamic pressure tester for fire hose and water gun

Fire hose and hose dynamic pressure testing machine is based on GB8181-2005 “fire hose” Article 6.1 requirements (the above standards), independent development, design and manufacture. It is used to determine the spraying performance, flow test, decompression and pressure stabilization test, pressure loss test, etc. of indoor hydrant, outdoor hydrant, fire hose, fire hose, nozzle, and groove type pipe joints. The product design of the outer tube is simple and generous, the test operation is simple and convenient, and the design of the large scre.

Product use: The testing machine is suitable for fire hose reel jet test, fire hose gun jet test and flow test, indoor hydrant decompression and stabilization of pressure performance and flow, outdoor hydrant regulator decompression and stabilization of pressure performance test, nozzle flow pressure test, trench pipe joints without sealing ring leakage performance. It can be widely used in the production and testing of fire protection products, and can meet the testing and inspection needs of production enterprises, testing centers, colleges and universities or scientific research institutions.

Technical Parameters：

1. Test medium: water
2. Test pressure range: 0-4.5MPa, pressure measurement accuracy: 0.2%F.S
3. Low-pressure pump: 0-0.7Mpa, flow rate 100m³/H
4. High pressure pump: 0.5~4.5Mpa, flow rate 12.5m³/H
5. Flow measurement accuracy: 0.2%F.S
6. Pressure sensing mode: current transmitter mode
7. Frequency conversion range: 0~50Hz; 75/50KW frequency conversion speed control
8. Elevation angle of injection: 30°±2°.
9. Spray gun center to the ground height: 1 ± 0.05m
10. Water tank: 15t horizontal; can be connected to the tap water to add water
11. Control cabinet size: 1160mm * 500mm * 1600mm
12. Instrument size: 11m * 6 * 2m